FUJI INVERTERS FRENIC-Eco series

Q 1: What is the background to development?
Q 2: What is the product concept?
Q 3: What is the difference between the Eco and the P11S?
Q 4: What is the Eco’s target application or best suited application?

Q 5: How long is the standard delivery term?
Q 6: When is the P11S scheduled to be discontinued?

Q 7:	How can we make commercial line/inverter switching operation?
Q 8:	In remote operation mode through communications, is it possible to operate the Eco from the keypad or to change the function code data on the keypad?
Q 9:	What happens if you enter an operation command to the Eco when the fan (or load motor) is running due to natural convection or wind?
Q10:	Is auto-tuning function available?
Q11:	How many control methods can we select?
Q12:	Is PID control supported?
Q13:	For external signal inputs, can we use 8-step multistep frequency selection, coast-to-stop command, plus trip command (external fault)?
Q14:	Is the electric power monitoring done through the keypad only ?
Q15:	Is the auxiliary control power input supported?
Q16:	Is automatic energy-saving operation possible?
Q17:	Is PID control supported?
Q18:	Does the Eco support the source mode of digital input?

Q19:	At least what function code should be set to run a motor with simplest variable speed operation?
Q20:	In F00 = “1: Enable data protection”, is it possible to switch between keypad operation and external signal input operation, from the key entry on the keypad?
Q21:	Although we want to set “enable data protection” at F00, changing the value from 0 to 1 is not successful. What should we do?
Q22:	Although we want to set “data initialization” at H03, changing the value from 0 to 1 is not successful. What should we do?
Q23:	Although we were able to change the setting of the sound tone (F27), the sound tone did not change at all. What should we do?
Q24:	Is there any function code that cannot be copied by using the copy function?
Q25:	What are the restrictions when we use the copy function?
Q26:	What is the guide for wiring length between the inverter, motor and operator box?
Q27:	Is the motor most unlikely to rotate even when the dew condensation prevention function is enabled?
Q28:	Is energy-saving operation possible even if auto-torque boost is selected?

Q29: How is the lifetime forecast function used?
Q30: What is the minimum unit of cooling fan cumulative running time?
Q31: Can the output of lifetime forecast function be received by external devices?
Q32: What does the displayed power consumption value show specifically?
Q33: What shall we do to see the alarm information on LED monitor?

Q34:	Is Eco’s DC REACTOR the same as that for the P11S or Mini series?
Q35:	Can we link the FRENIC-Mini with a personal computer? If so, what software is used?
Q36:	Is a copy unit supported?
Q37:	How does the Eco comply with Japanese Guideline for Suppressing Harmonics?
Q38:	We plan to install an AC reactor in addition to a DC REACTOR for harmonic suppression. Could the voltage drop have any influence on the output voltage?
Q39:	What is the difference in the usage between the output circuit filter, power filter and EMC compliance filter?
Q40:	What happens if the output circuit filter is used outside the allowable carrier frequency range?

Q41:	How does or will the FRENIC-Eco comply with international standards?
Q42:	Can we drive two or more motors with a single Eco inverter simultaneously?
Q43:	Can we replace the existing motor, including other manufacturers’ with the FRENIC-Eco?
Q44:	Can the Eco generate a frequency output of 400Hz or over, equivalent to those of the G11S or Mini series?
Q45:	Does the Eco have the explosion-proof approval?